JR Direct Radio XP662 User Manual download pdf (Page 74)

XP662 MANUAL Helicopter

Accessing the Throttle Curve Function

Adjustment of the throttle curve is very similar to

the pitch curve adjustment described in the

preceding section. A thorough understanding of the

pitch curve section will make the throttle curve

section easier to understand.

There are two independent types of throttle curves

available—normal and stunt. The normal or hover

throttle curve has three reference points (L,2, H) and

the stunt or flight throttle curve has two reference

points (L and 2).

The two throttle curves are activated by the flight

mode switch located on the top left rear corner of

the transmitter. The throttle curve is in the normal

condition when the flight mode switch is in the back

position. The throttle curve is in the stunt condition

when the flight mode switch is in the forward position.

Note: In Stunt mode (S), the high position of the

throttle curve is preset to 100%, and is not adjustable.

1. Turn on the transmitter.

2. Press the SCROLL and INCREASE buttons

simultaneously to enter the function mode.

3. Press the SCROLL button until “TLN” appears on

the screen. The letter to the far right indicates

the specific throttle curve section that you are in

(N, S, or H). The letter in the center indicates the

reference point that you are in.

4. Press the CHANNEL button to select the

reference

point of the throttle curve you want to

change (L, 2, or H*).

5. Press the INCREASE or DECREASE button to

change the value of the current reference point.

The range of each point is 0–100% in 1% intervals.

6. To set the throttle curve for the stunt (flight)

mode, press the SCROLL button once. Then,

repeat Steps 5 and 6 to adjust.

7. Press the SCROLL button once to access the

Revolution Mixing function.

8. To exit, press the SCROLL and INCREASE

buttons simultaneously.

* Normal mode only.

THROTTLE CURVE7.8

CHAPTER 7: FUNCTIONS (FUNCTION MODE)

•

Helicopter

THROTTLE CURVE VALUE (0-100%)

TLN

SWITCH POSITION

Flashing when switch position

and display are the same

N: NORMAL

S : STUNT

H: HOLD

Only visible when the hold

function is activated

POINT DISPLAY/STICK POSITION

L : LOW 0%

2 : CENTER 50%

H: HIGH 100%

Press the SCROLL button until

“TLN” appears on the screen.

Press again to access Stunt mode.

Press the CHANNEL button to

select the desired point

display/stick position.

Press the INCREASE or

DECREASE button to adjust

the throttle curve value.

CHANNEL

SCROLL

INCREASE

DECREASE

ENTER

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 87 88

Comments to this Manuals

No comments

JR Direct Radio XP662 User Manual Page 74

Comments to this Manuals