JR Direct Radio XP662 User Manual download pdf (Page 31)

XP662 MANUAL Airplane

CHAPTER 6: FUNCTIONS (SYSTEM MODE)

•

Airplane

HO = ALL SERVOS HOLD

0.3 = 1/3 SECOND TIME DELAY

0.5 = 1/2 SECOND TIME DELAY

1.0 = 1 SECOND TIME DELAY

FST

Setting Fail-Safe/Hold Time Delay/Memory In Z-PCM Modulation

Press either the INCREASE or

DECREASE buttons to select

the desired time delay.

HOLD

0.3 SECONDS

0.5 SECONDS

1.0 SECONDS

1. After accessing the Fail-Safe function, it is now

time to adjust the fail-safe time presets.

2. Select among the three time delays (0.3, 0.5, or

1.0 seconds) by pressing either the (+) or (-) buttons

until the desired setting appears on the screen.

Note: If the Hold position (HO) is selected, this

function/screen will not be present.

1. Press the SCROLL button until “FSM” appears on

the screen.

2. Set all controls to the desired fail-safe position,

then press the CHANNEL and INCREASE buttons

simultaneously. A high-pitch beep sound will

confirm that the preset positions have been entered.

3. Hold the transmitter sticks in the position that

you want the servos to assume during signal loss

conditions. You can determine fail-safe preset

positions for the other channels by placing the

control knobs and switches in the positions that

you want them to assume during interference.

4. With the sticks, switches and control knobs in

the fail-safe positions, press the CHANNEL and

INCREASE buttons simultaneously. This will

enter these locations as the fail-safe memory

settings. A high-pitched beep will indicate that

this setting has been stored.

5. To confirm that the input of data was successful,

switch the transmitter off. The controls will move

to the input locations. If not, repeat Step 4 again.

6. To exit the Fail-Safe function, press the SCROLL

and INCREASE buttons simultaneously.

Note: These preset positions remain stored in the

transmitter’s memory until both the transmitter

battery pack and the lithium back-up battery have

been removed (or until data reset has been performed).

Therefore, you do not have to reset the fail-safe each

time you fly. Should you want to re-adjust the fail-

safe presets, access the Fail-Safe function and adjust

the presets as you havejust done. The transmitter

automatically recalls the settings for the

last fail-safe adjustment.

CL WILL FLASH WHEN FAIL-SAFE

SERVO POSITIONS ARE

ENTERED.

FSM

Press the CHANNEL and INCREASE buttons

simultaneously to store the fail-safe servo presets.

FAIL-SAFE/HOLD FUNCTIOn IN Z-PCM MODULATION (continued)

6.9

Setting Servo Position Presets

CHANNEL

SCROLL

INCREASE

DECREASE

ENTER

CHANNEL

SCROLL

INCREASE

DECREASE

ENTER

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 87 88

Comments to this Manuals

No comments

JR Direct Radio XP662 User Manual Page 31

Comments to this Manuals